hd97048 radial extension

Got a calibration problem? Discuss it here.

Moderator: Mark.Wieringa

hd97048 radial extension

Postby bnorfolk » Tue Jun 30, 2020 4:06 pm

Hi,

I'm getting some significant radial emission on the reduction of hd97048 (cucha) from the 30 aug 2014 track contrary to what was published in van der Plas 2017. Here's my reduction steps:

1. No seemon values flagged

2. BPcal 1253-055
- blflag on spread between 18h06m – 18h20m 33/35 GHz
- flagged ant 6 on 33ghz
- MFcal int=0.1
- 5.698Jy measured

3. Gpcopy
- bpcal sol onto phasecal
- bpcal sol onto fluxcal

4. Fluxcal 1934-638
- flagged deviating amp vs time
- MFcal int=0.1 options=nopassol

5. Phasecal 1622-253
- Flagged ant 5 35ghz
- flagged all obs from -03:00:00 to 05:30:00 given deviation
- I flux 3.262
- MFcal int=0.1 options=nopassol

6. GPboot
- time(05:30:00,06:00:00)

Now in this reduction I've carried out significant flagging in an attempt to remove the radial emission with no success. Also, I understand I've significantly flagged most of the phase cal, I did this to try and remove the radial emission - obviously this didn't work. Previous reductions with less flagging on the phase cal produced the same results.

As I reduce my obs I scan the BPcal, fluxcal, and phasecal chan vs amp, time vs amp, and time vs phase plots. But they all seem to be within reasonable values. I've attached all relevant figures in a zip folder.

Any advice would be greatly appreciated.

Cheers,
Brodie
Attachments
hd97048_images.zip
(996.66 KiB) Downloaded 34 times
bnorfolk
 
Posts: 41
Joined: Fri May 17, 2019 3:56 pm

Re: hd97048 radial extension

Postby Mark.Wieringa » Tue Jun 30, 2020 7:01 pm

Hi Brodie,

I think this question might be a bit beyond what we can answer. The article states that radial structures were noticed in the Aug 31 track, which had poor phase stability, so if you are getting some of these effects in the data for the 30th, it may be a similar issue, i.e., phase errors. Their peak flux value is a bit higher as well, which would come with better calibration. Their image is cropped almost to the point where the partial ring that shows up in your version would be invisible. You could try cleaning you image a bit further, but you may need to improve the calibration first. That said, your calibration plots look fine to me and there are no obvious phase error patterns in the image - but this can be hard to tell with more extended sources.

Cheers,

Mark
Mark.Wieringa
ATCA Expert
 
Posts: 284
Joined: Mon Feb 08, 2010 1:37 pm

Re: hd97048 radial extension

Postby bnorfolk » Wed Jul 01, 2020 2:16 pm

Thanks for the reply Mark.
bnorfolk
 
Posts: 41
Joined: Fri May 17, 2019 3:56 pm


Return to Calibration

Who is online

Users browsing this forum: No registered users and 0 guests

cron