I just input those commands and the result was the same error message as before.
Really not sure what to make of this.
Search found 5 matches
- Fri Jun 13, 2014 2:57 am
- Forum: MIRIAD
- Topic: Bandpass table size incorrect - Error in mfboot
- Replies: 12
- Views: 29699
- Thu Jun 12, 2014 9:17 pm
- Forum: MIRIAD
- Topic: Bandpass table size incorrect - Error in mfboot
- Replies: 12
- Views: 29699
Re: Bandpass table size incorrect - Error in mfboot
Thanks for the quick reply.
Went through the steps again without using gpcal on Neptune and got the same error message, again the flux scale has been applied so is it possible that the step has worked and just produced the error message for no reason?
Went through the steps again without using gpcal on Neptune and got the same error message, again the flux scale has been applied so is it possible that the step has worked and just produced the error message for no reason?
- Thu Jun 12, 2014 2:59 am
- Forum: MIRIAD
- Topic: Bandpass table size incorrect - Error in mfboot
- Replies: 12
- Views: 29699
Re: Bandpass table size incorrect - Error in mfboot
I just ran into this problem and couldn't solve it using the tips listed above. My calibration steps are as follows: mfcal vis=bandpass refant=2 interval=0.2 select="time( good time )" gpcopy vis=bandpass out=gain gpcopy vis=bandpass out=flux gpcal vis=gain options=xyvary,qusolve gpcal vis...
- Thu Jun 12, 2014 2:45 am
- Forum: MIRIAD
- Topic: Callers buffer channel error
- Replies: 2
- Views: 5211
Re: Callers buffer channel error
Thanks for the Info!
Wasn't successful in installing the 64 bit miriad version but managed to split the files using remote access to a Linux based machine that could handle the extra channels.
Wasn't successful in installing the 64 bit miriad version but managed to split the files using remote access to a Linux based machine that could handle the extra channels.
- Sat Jun 07, 2014 10:03 pm
- Forum: MIRIAD
- Topic: Callers buffer channel error
- Replies: 2
- Views: 5211
Callers buffer channel error
I'm currently using a Miriad macport to process CABB data taken by my supervisor from 2010 to 2011. I've recently run into a problem with some of the larger 3mm data sets where running uvsplit produces the following error message: "Callers buffer too small for channel data, in UVREAD". I'v...