Hi everyone,
I need to calculate the total flux error for my detected sources. I know the local rms noise but I need to have calibration error for CABB and pre-CABB to calculate the total flux error. Does anybody have any experience about this issue?
Cheers,
Sara
Calibration error for CABB
Moderator: Mark.Wieringa
-
Mark.Wieringa
- ATCA Expert
- Posts: 297
- Joined: Mon Feb 08, 2010 1:37 pm
Re: Calibration error for CABB
Hi Sara,
It depends a bit on frequency and the weather at the time of your observation, but 5-10% is a reasonable starting number.
See http://atcaforum.atnf.csiro.au/viewtopic.php?p=373#p373 for more discussion on this.
Cheers,
Mark
It depends a bit on frequency and the weather at the time of your observation, but 5-10% is a reasonable starting number.
See http://atcaforum.atnf.csiro.au/viewtopic.php?p=373#p373 for more discussion on this.
Cheers,
Mark